Reamer flutes are located at the front of the device as seen in the image above. Small chips are removed by flowing along flutes in the reamer. Flutes can be divided into two general categories: straight and helix. Helix can be further divided into four variations: right hand, left hand, slow, and fast.
Reamers are normally supplied with straight flutes or Helical Flutes for general purpose thru hole reaming.
Material: HSS M-2, M-35, HSS Co8e and Carbide
As per DIN / BS and ISO standards
These are used for used for machine-reaming ‘through’ holes.
STRAIGHT / SPIRAL FLUTED
Material: HSS M-2, M-35, HSS Co8e
As per DIN / BS and ISO standards
These Reamers are used for machine-reaming ‘through’ & most ‘blind’ holes.
STRAIGHT / SPIRAL FLUTED
Material: HSS M-2, M-35, HSS Co8e
As per DIN / BS and ISO standards
STRAIGHT / SPIRAL FLUTED
Material: HSS M-2, M-35, HSS Co8e
As per DIN / BS and ISO standards
These are used for used for machine-reaming ‘through’ holes.
STRAIGHT / SPIRAL FLUTED
Material: HSS M-2, M-35, HSS Co8e
As per DIN / BS and ISO standards
Tool Masters is the leading innovator and manufacturer of a wide range of precision Cutting Tools. Our product quality and range is well supported by ‘State-of-the-art’ machines for manufacture with a strict in-process control. High quality raw material, the best heat treatments and coatings along with personnel experience have always enabled us....
If you have any questions regarding our products and services please use the form below and one of our representatives will be in touch shortly.
© COPYRIGHT 2023 Smart Solutions | All Rights Reserved